Email this article Production of Large Disks from Cylindrical Blanks by Plastic Deformation. 1. Formulation of the Problem
- Authors: Vorontsov A.L.1
-
Affiliations:
- Bauman Moscow State Technical University
- Issue: Vol 39, No 6 (2019)
- Pages: 477-479
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227727
- DOI: https://doi.org/10.3103/S1068798X19060200
- ID: 227727
Cite item
Open Access
Access granted
Subscription Access
Abstract
Abstract—The plastic deformation of large disks and hard-to-deform disks on low-power equipment is considered. In comparison with upsetting and flattening by forging, sectional bulk stamping is promising. It permits successive plastic deformation of individual sections of the blank.
About the authors
A. L. Vorontsov
Bauman Moscow State Technical University
Author for correspondence.
Email: mt13@bmstu.ru
Russian Federation, Moscow
Supplementary files
