Email this article Depth of the Disintegrated Layer in the Abrasive Finishing of Single Crystals
- Authors: Muratov K.R.1, Ablyaz T.R.1, Gashev E.A.1
-
Affiliations:
- Perm National Research Polytechnic University
- Issue: Vol 39, No 10 (2019)
- Pages: 875-877
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227828
- DOI: https://doi.org/10.3103/S1068798X19100198
- ID: 227828
Cite item
Open Access
Access granted
Subscription Access
Abstract
The abrasive finishing of monocrystalline lithium niobate is considered. The action of abrasive grains on the surface of the workpiece creates a layer of disintegrated material. The depth F of the disintegrated layer may be calculated as F = 12h, where h is the height of the surface relief, corresponding to the roughness Rmax.
About the authors
K. R. Muratov
Perm National Research Polytechnic University
Author for correspondence.
Email: Karimur_80@mail.ru
Russian Federation, Perm
T. R. Ablyaz
Perm National Research Polytechnic University
Author for correspondence.
Email: unpl_mtf@pstu.ru
Russian Federation, Perm
E. A. Gashev
Perm National Research Polytechnic University
Email: unpl_mtf@pstu.ru
Russian Federation, Perm
Supplementary files
