Email this article Turning of F-4UV20 Composite Plastic
- Authors: Ablyaz T.R.1, Matygullina E.V.1, Sirotenko L.D.1, Tokarev D.I.1, Drozdov A.A.1
-
Affiliations:
- Perm National Research Polytechnic University
- Issue: Vol 39, No 10 (2019)
- Pages: 884-885
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227845
- DOI: https://doi.org/10.3103/S1068798X19100034
- ID: 227845
Cite item
Open Access
Access granted
Subscription Access
Abstract
The turning of F-4UV20 composite plastic is investigated. Continuous chip is formed in all the experimental conditions: cutting speed 16–100 m/min; supply 0.05–0.2 mm/turn; cutting depth 0.5–2 mm. The wear of the cutting insert is uniform (0.1 mm at the rear surface and 0.3 mm at the front surface), with no traces of adhesion. After turning, carbon fibers remain on the machined surface, conferring antifrictional properties without significant effect on the roughness.
About the authors
T. R. Ablyaz
Perm National Research Polytechnic University
Email: dron.perm@list.ru
Russian Federation, Perm
E. V. Matygullina
Perm National Research Polytechnic University
Author for correspondence.
Email: matik68@rambler.ru
Russian Federation, Perm
L. D. Sirotenko
Perm National Research Polytechnic University
Author for correspondence.
Email: sirotenko@pstu.ru
Russian Federation, Perm
D. I. Tokarev
Perm National Research Polytechnic University
Author for correspondence.
Email: den.tokarev.201@yandex.ru
Russian Federation, Perm
A. A. Drozdov
Perm National Research Polytechnic University
Author for correspondence.
Email: dron.perm@list.ru
Russian Federation, Perm
Supplementary files
