Email this article Mechanical Properties of Products after Electric-Discharge Machining
- Authors: Ablyaz T.R.1, Vil’deman V.E.1, Muratov K.R.1, Il’inykh A.V.1
-
Affiliations:
- Perm National Research Polytechnic University
- Issue: Vol 39, No 10 (2019)
- Pages: 892-894
- Section: Article
- URL: https://journal-vniispk.ru/1068-798X/article/view/227868
- DOI: https://doi.org/10.3103/S1068798X19100046
- ID: 227868
Cite item
Open Access
Access granted
Subscription Access
Abstract
The mechanical properties of 38Х2Н2МА steel components after electric-discharge machining (EDM) are experimentally studied. The strength of workpieces obtained by turning and EDM is compared. The life of samples in few-cycle fatigue is determined. The life of 38Х2Н2МА steel samples after EDM is 30% less than after turning. There is little difference in the strength of 38Х2Н2МА steel samples after EDM and after turning.
About the authors
T. R. Ablyaz
Perm National Research Polytechnic University
Author for correspondence.
Email: lowrider11-13-11@mail.ru
Russian Federation, Perm
V. E. Vil’deman
Perm National Research Polytechnic University
Email: karimur_80@mail.ru
Russian Federation, Perm
K. R. Muratov
Perm National Research Polytechnic University
Author for correspondence.
Email: karimur_80@mail.ru
Russian Federation, Perm
A. V. Il’inykh
Perm National Research Polytechnic University
Email: karimur_80@mail.ru
Russian Federation, Perm
Supplementary files
