Assignment of the Abrasive-Jet Machining Mode of Si3N4-Ceramic Components Considering the Stress State of Various Surface-Layer Phases
- Authors: Kuzin V.V.1, Fedorov M.Y.1, Volosova M.A.1
-
Affiliations:
- Stankin Moscow State Technological University
- Issue: Vol 59, No 4 (2018)
- Pages: 420-424
- Section: Article
- URL: https://journal-vniispk.ru/1083-4877/article/view/249108
- DOI: https://doi.org/10.1007/s11148-018-0247-8
- ID: 249108
Cite item
Abstract
The influences of mechanical and thermal actions specific to abrasive-jet machining on the distribution of stresses in various surface-layer phases of Si3N4 ceramic were investigated. An approach to selecting the operating modes during preliminary and finishing processes was proposed based on the established trends.
Keywords
About the authors
V. V. Kuzin
Stankin Moscow State Technological University
Author for correspondence.
Email: kuzena@post.ru
Russian Federation, Moscow
M. Yu. Fedorov
Stankin Moscow State Technological University
Email: kuzena@post.ru
Russian Federation, Moscow
M. A. Volosova
Stankin Moscow State Technological University
Email: kuzena@post.ru
Russian Federation, Moscow
Supplementary files
