Email this article Algorithm of minimization of tool idle movements during milling of complex surfaces on 3-axis CNC machines
- Authors: Ponomarev B.B1, Nguen V.N.1
-
Affiliations:
- National Research Irkutsk State Technical University
- Issue: Vol 8, No 2-2 (2014)
- Pages: 85-88
- Section: Articles
- URL: https://journal-vniispk.ru/2074-0530/article/view/67699
- DOI: https://doi.org/10.17816/2074-0530-67699
- ID: 67699
Cite item
Full Text
Abstract
The paper presents one of the methods of nonproductive machine time optimization of tools during milling of parts with complex surfaces on combined machine. In particular, there was described an algorithm to minimize the idle movements of spherocylindrical and conical cutters. Calculations were performed on the test parts with complex surfaces.
Full Text
##article.viewOnOriginalSite##About the authors
B. B Ponomarev
National Research Irkutsk State Technical University
Email: pusw@istu.edu. namng85@gmail.com
Dr. Eng., Prof; +7 395 240-50-20, +7 924 606-86-68
Van Nam Nguen
National Research Irkutsk State Technical University
Email: pusw@istu.edu. namng85@gmail.com
+7 395 240-50-20, +7 924 606-86-68
References
- Бердников Л.Н. Работа на фрезерных станках. Л.: Лениздат, 1987. 206 с.
- Голованов Н.Н. Геометрическое моделирование. М.: Физматлит, 2002. 472 с.
- Пономарёв Б.Б., Нгуен Ван Нам. Алгоритм оптимизации вспомогательных перемещений инструментов при фрезеровании сложных поверхностей // Вестник Иркутского Государственного Технического Университета. 2013. №1. С. 33-37.
- Технология машиностроения: в 2 т. / под ред. А.М. Дальского. М.: МГТУ, 2001. 564 с.
Supplementary files
